Rennsimulanten Merchandise Shop

G25 throttle axis problem -> sensor cleaning

Mehr
15 Jahre 10 Monate her #274181 von Rennsimulant
on a straight i noticed i was fallin back to 60% throttle sometimes. Sucks if u lookin for 0,5 sec's i gues =)

so i open the pedal box (first remove pedal plate's) and find lots of cat hairs and other dust. clean all , grease black plastic gears again, inside case must be 100% clean
let some oil go thru the sensors (cooling oil to drill holes i used)
this takes al dirt along with it
after this i blowed it out with air compressor
immediatly tyred it out,
and the signal was stable again
before it was jumping around the whole time...
also check if all plastik greased-gears connected to the sensor-levers are still in the right position (the same position as the other 2)

Full Throttle greetings
pSyTech

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
15 Jahre 10 Monate her #274183 von 29manzglade
Thanks psytech, you know I have the same problem (we talked about it at Oldring), so I think it is just the potentiometer (dunno if there is an english translation ^^ ) wich needs a bit of Mos2 or sth. similar.
Will give it a try next week. Thanks for your Post.
Cheers
Maxi

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
15 Jahre 10 Monate her #274186 von Rennsimulant
yup flush the potentiometer/sensor with oil will do the trick

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Ladezeit der Seite: 0.113 Sekunden
No module Published on Offcanvas position